2007 Arctic Cat 700 Diesel ATV Service Manual, Page 163Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 163

MeasuringAdjusting Toe-In 1Thoroughly wash the ATV to remove excess weight (mud, etc2Refer to the specifications and ensure
positionNOTE: When measuring and adjusting, there should be normal operating load on the ATV 4Measure the distance from the
outside edge of each handlebar grip to equal reference points on each side 8Pump the hand brake lever; then engage the brake
lever lock9Secure the hub nut (from step 6) to the shaftTighten to specifications10Install new cotter pin and spread the
pin to secure the nut11Install the wheel; then using crisscross pattern, tighten to specifications12Remove the ATV from the
support stand8-6 5Adjust the handlebar direction until the two measurements are equal; then secure the handlebar to the rear