2007 Arctic Cat 700 Diesel ATV Service Manual, Page 165Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 165

12If the difference in the measurements is not within specifications, adjust both tie rods equally until within specificationsNOTE:
1Place the front bumper assembly into position and install the through-boltStart the lock nut and finger-tighten only2Install
the two flange bolts and lock nuts on the upper supportsTighten all hardware securely FrontRear Body Panel REMOVING 1Remove
the seat; then remove the tool tray2Remove the negative battery cable3Remove the reinstallable rivets securing the steering
post cover and the radiator access cover; then remove the covers4Remove the left-side and right-side fender splash panels;
then remove one press-in fastener and one reinstallable rivet from the left side and right side of the air-intake splash
shroudDo not remove the shroud5Disconnect the four headlight connectors and the taillightbrakelight connector from the sockets
1Clean all rack components2Inspect all welds for cracking or bending3Inspect threaded areas of all mounting bosses for stripping4Inspect