2007 Arctic Cat 700 Diesel ATV Service Manual, Page 170Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 170

NOTE: It may be necessary to rotate the body panel to the right to align the opening with the handlebar 3Make sure the four
for any missing decalsINSTALLING 1Rotate the handlebar to the full-left position; then place the front body panel over the
handlebar and rotate and lower into positionCD679A 4Install one cap screw and flange nut and four plastic rivets on each
side to secure the front fenders to the footwellsTighten the flange nuts securelyNOTE: If the footwells have been removed,
see Footrests in this section 5Install four cap screws securing the front body panel to the frame and rear panel 2Connect