2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 14Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 14

Lubrication Points It is advisable to lubricate certain components periodically to ensure free movementApply light oil to
necessary; then install vent plugs ! CAUTION Before installing the battery, make sure the ignition switch is in the OFF position
! WARNING Battery acid is harmful if it contacts eyes, skin, or clothingCare must be taken whenever handling battery 6Place
the battery into position in the ATV and secure with the hold-down bracket7Attach the vent tube and check the vent tube to
make sure it is not crimped or obstructed in any way and that it is properly routed through and secured to the frame8Connect
cables to the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative terminal (-)Connect
the negative cable last If the battery is discharged, remove the battery from the ATV and charge the battery at 1.5 amps
for 10 hoursTo remove and charge the battery, use the following procedure ! WARNING Anytime service is performed on battery,
the following must be observed: keep sparks, open flame, cigarettes, or any other flame awayAlways wear safety glassesProtect