2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 17Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 17

11Install the air filter housing cover and secure with the retaining clips (400500650 H1) or wing-nuts (700 EFI)12Install
in VALVETAPPET CLEARANCE (650 H1) Intake Exhaust 0.1016 mm (0.004 in 0.1524 mm (0.006 in 2Replace any one-way drain that
is cracked or shows any signs of hardening or deterioration ! CAUTION The one-way drain to the right is the clean air section
of the filter housingAny leak of this one-way drain will allow dirt into the engine intake causing severe engine damage 3Wipe
any accumulation of oil or gas from the filter housing and one-way drainsCC007DB (Feeler Gauge Procedure) NOTE: For the 700
EFI, see ValveTappet Clearance (700 EFI) in this section ValveTappet Clearance 4Install the timing inspection plug5Place
the two tappet covers into position making sure the proper cap screws are with the proper coverTighten the cap screws securely
To check and adjust valvetappet clearance, use the following procedure1Remove the timing inspection plug; then remove the
tappet covers (for more detailed information, see SectionServicing Top-Side Components)2Rotate the crankshaft to the TDC