2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 27Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 27

SuspensionShock AbsorbersBushings The following suspension system components should be inspected periodically to ensure proper
replacing the headlight bulb, do not touch the glass portion of the bulbIf the glass is touched, it must be cleaned with
dry cloth before installingSkin oil residue on the bulb will shorten the life of the bulb NutsBoltsCap Screws Tighten all
nuts, bolts, and cap screwsMake sure rivets holding components together are tightReplace all loose rivetsCare must be taken
that all calibrated nuts, bolts, and cap screws are tightened to specifications (see Section 10) ! WARNING Do not attempt
to remove the bulb when it is hotSevere burns may result To replace the headlight bulb, use the following procedure1Remove
the wiring harness connector from the back of the headlight2Grasp the bulb housing, turn it counterclockwise, and remove
the bulb3Install the new bulb into the housing and rotate it completely clockwise4Install the wiring harness connectorTAILLIGHT-BRAKELIGHT