2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 31Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 31

Hydraulic Brake Systems CHECKINGBLEEDING CRemove the protective cap, install one end of clear hose onto one FRONT bleeder
to check for firm brakeIf the brake is not firm, the system must be bled3To bleed the brake system, use the following procedureARemove
the cover and fill the reservoir with DOT Brake FluidBInstall and secure the cover; then slowly compress the brake lever
several times NOTE: During the bleeding procedure, watch the reservoir sight glass very closely to make sure there is always
sufficient amount of brake fluidWhen the sight glass changes from dark to light, refill the reservoir before the bleeding
procedure is continuedFailure to maintain sufficient amount of fluid in the reservoir will result in air in the system DRepeat
step until the brake lever is firmEAt this point, perform step B, C, and on the other FRONT bleeder screw; then move to the