2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 32Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 32

! CAUTION This hydraulic brake system is designed to use DOT brake fluid onlyIf brake fluid must be added, care must be taken
the wheelTighten to specifications5Burnish the brake pads (see Burnishing Brake Pads in this section) Burnishing Brake Pads
NOTE: The brake pads should be replaced as set 4To replace the brake pads, use the following procedureARemove the wheelBRemove
the cap screws securing the caliper holder to the knuckle; then remove the pads Brake pads (both hydraulic and auxiliary)
must be burnished to achieve full braking effectivenessBraking distance will be extended until brake pads are properly burnishedTo
properly burnish the brake pads, use the following procedure ! WARNING Failure to properly burnish the brake pads could lead
to premature brake pad wear or brake lossBrake loss can result in severe injury 1Choose an area large enough to safely accelerate