2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 33Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 33

3Repeat procedure on each brake system five times until brake pads are burnished4Adjust the auxiliary brake (if necessary)5Verify
to the bottom of the stand pipe in the radiator neck NOTE: Note the location of the main engine ground wire for installing
purposes 3Remove the nut securing the movable drive face; then remove the faceAccount for the spacer ! CAUTION After operating
the ATV for the initial 5-10 minutes, stop the engine, allow the engine to cool down, and check the coolant levelAdd coolant
as necessary CheckingReplacing V-Belt REMOVING 1Remove the right-side footrest (see Section 8)2Remove the cap screws securing