2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 82Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 82

1If backlash measurement is less than specified, remove an existing shim, measure it, and install new thinner shim2If backlash
dye to several teeth of the gear4Install the secondary driven output shaft assembly5Rotate the secondary driven bevel gear
several revolutions in both directions6Examine the tooth contact pattern in the dye and compare the pattern to the illustrationsCorrecting
Tooth Contact NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction is necessary
If tooth contact pattern is comparable to an incorrect pattern, correct tooth contact according to the following chartTooth
Contact Contacts at Top Contacts at Root Shim Correction Decrease Shim Thickness Increase Shim Thickness NOTE: To correct
tooth contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim Correction"
chart must be consulted ! CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue