2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 83Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 83

CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod
and base on the surface platePosition the indicator contact point against the center of the connecting rod small end journal2Zero
the indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection must not exceed
specificationsMeasuring Connecting Rod (Big End Side-to-Side) 1Push the lower end of the connecting rod to one side of the
crankshaft journalATV-1074 2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal 3Zero the
indicator and rotate the crankshaft slowly ! CAUTION Care should be taken to support the connecting rod when rotating the
crankshaft 4Maximum runout must not exceed specificationsNOTE: Proceed to check runout on the other end of the crankshaft