2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 109Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 109

EWhile holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valvetappet
31If removed, install the spark plug and tighten to specificationsCD821 Installing EngineTransmission NOTE: Arctic Cat recommends
that new gaskets and O-rings be installed whenever servicing the ATV 4Remove the block from beneath the engine; then align
the rear drive flanges and secure with four cap screwsTighten to specifications 1From the left side, place the enginetransmission
into the frame; then move it rearward as far as possible2Raise the rear of the engine enough to engage the front driveshaft
into the splines of the front drive output yoke; then slide the engine forward as far as possibleCD824 5Install the lower