2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 116Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 116

26Remove the engine from the left side by moving the engine forward while raising the engine in the rear and rotating the
valve cover cap screwsNote the rubber washers on the four top-side cap screws; remove the valve coverNote the orientation
of the cylinder head plug and remove itNote the location of the two alignment pins Removing Top-Side Components AValve Cover
BCylinder Head NOTE: Remove the spark plug and timing inspection plug; then using the recoil starter, rotate the crankshaft
to top-dead-center of the compression strokeNOTE: Arctic Cat recommends the use of new gaskets, lock nuts, and seals and
lubricating all internal components when servicing the enginetransmissionMD1261 1Remove the cap screws securing the two tappet
coversRemove the two tappet coversAccount for the O-rings MD1354A 3Loosen the cap screw on the end of the cam chain tensioner;