2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 146Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 146

Servicing Center Crankcase Components NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
in both directions6Examine the tooth contact pattern in the dye and compare the pattern to the illustrations Checking Backlash
NOTE: The rear shaft and bevel gear must be removed for this procedureAlso, always start with the original shims on the rear
shaft 1Place the left-side crankcase cover onto the left-side crankcase half to prevent runout of the secondary transmission
output shaft2Install the secondary driven output shaft assembly onto the crankcase3Mount the indicator tip of the dial indicator
on the secondary driven bevel gear4While rocking the driven bevel gear back and forth, note the maximum backlash reading
on the gauge5Acceptable backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting Backlash NOTE: If backlash measurement is
within the acceptable range, no correction is necessary 1If backlash measurement is less than specified, remove an existing