2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 148Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 148

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing
Disassembling 3Zero the indicator and rotate the crankshaft slowly 1Remove the reverse driven gear dog; then remove the circlip
securing the reverse driven gear2Remove the reverse driven gear and account for the washer, bushing, and bearing3Remove the
low driven gear washer; then remove the low driven gearAccount for the bushing and bearing4Remove the washer; then remove
the circlip securing the sliding dogRemove the sliding dog5Remove the high driven gear circlip; then remove the high driven
gearAccount for the washer, bushing, and bearing ! CAUTION Care should be taken to support the connecting rod when rotating
the crankshaft 4Maximum runout must not exceed specificationsNOTE: Proceed to check runout on the other end of the crankshaft