2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 149Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 149

Assembling Disassembling 1Remove the small and large washers from the balancer shaft2Note the position of the alignment marks
the reverse driven gear onto the countershaft making sure the bearing, bushing, and washer are properly positioned; then
secure with the circlip5Place the reverse driven gear dog onto the countershaft; then secure with the circlipNOTE: The countershaft
is now completely assembled for installation 1Place driven gear #2 into driven gear #1; then align the alignment marks of
driven gear #1 and driven gear #22Using pair of needle-nose pliers, insert each spring part way into the slot; then install
pin and push the springpin assembly into the slot3Place the key and the large washer into position on the balancer shaft4Place
the driven gear #1 assembly onto the balancer shaft; then place the large and small washers onto the shaftNOTE: The crank
balancerdriven gear assembly is now completely assembled for installation Assembling Crankcase Half NOTE: For ease of assembly,