2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 152Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 152

11Install the secondary and primary driveshaft assembliesAccount for the bearing alignment C-ring on the bearing boss next
joined; then tighten to specificationsNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6In
crisscrosscase-to-case pattern, tighten the mm cap screws to specificationsNOTE: Rotate the shafts back and forth to ensure
no binding or sticking occursMD1336 AT THIS POINT After completing center crankcase components, proceed to Installing Right-Side
Components, to Installing Left-Side Components, and to Installing Top-Side Components 2Using plastic mallet, lightly tap
the case halves together until cap screws can be installed3From the right side, install the crankcase cap screws noting the