2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 156Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 156

18Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the
screws securely 2Install the starter motor and tighten the two cap screws securelyMD1033 3Install the driveshaft spacer making
sure the stepped side is to the inside NOTE: At this point, the wedge can be removed from between the driven pulley faces
19Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven pulley20Install two alignment
pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position of the