2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 158Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 158

12Place the gasket, recoil starter assembly, and cover into position on the left-side cover making sure the single washer
on each side and the open end of the circlip is directed upwards or downwardsNOTE: The piston should be installed so the
arrow points towards the exhaust ATV-1085B NOTE: Note the direction of the exhaust side of the piston (5) for correct ring
end gap orientation BInstall the compression rings (1 and 2) so the letter on the top surface of each ring faces the dome
of the pistonRotate the rings until the ring end gaps are on directly opposite sides of the piston according to the illustrationNOTE:
The chrome (silver) ring should be installed in the top position 2Place the two alignment pins into positionPlace the cylinder