2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 160Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 160

11While holding the cam chain sprocket to the side, install the rear cam chain tensioner guide into the cylinder headInstall
assembly is seated, make sure the alignment pin in the camshaft aligns with the smallest hole in the sprocket 8Install the
two lower nuts securing the cylinder head to the cylinder, one in front and one in rear 13With the alignment pin installed
in the camshaft, loosely place the cam sprocket (with the recessed side facing the camshaft lobes) onto the camshaft and
place it into position with the cam chain over the sprocket MD1359 MD1192 9In crisscross pattern, tighten the four cylinder
head cap screws (from step 7) to specificationsTighten the two lower cylinder head nuts (from step 8) to specifications and
the cylinder-to-crankcase nuts (from step 4) to specifications10With the timing inspection plug removed and the cam chain