2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 176Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 176

3Using cold chisel, scribe mark showing the relative position of the shift arm to the shift arm shaft to aid in installing;
then remove the housingAccount for the gasket and two seal washers NOTE: Inspect the inside of the left-side cover for any
shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter
idler gear spacer is on the shaft or in the cover 5Loosen the clamps securing the coolant hose to the water pump; then remove
the crossover tube from the cylinder headAccount for an O-ring 9Remove the nut securing the magneto rotor to the crankshaft;
then install the magneto rotor puller adapterNOTE: The puller has left-hand threads 10Using Magneto Rotor Remover Set (pn