2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 194Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 194

9Remove the spring from the case by lifting the spring end up and outHold the remainder of the spring with thumbs and alternately
1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in the case;
then wind it in counterclockwise direction until the complete spring is installedNOTE: The spiral spring must seat evenly
in the recoil case ! WARNING Care must be taken when lifting the reel free of the caseWear safety glasses to avoid injury
8Remove the protective cover from the starter handle and pull the rope out of the handle; then untie the knot in the rope
and remove the handleNOTE: Do not remove the spiral spring unless replacement is necessaryIt should be visually inspected
in place to save timeIf replacement is necessary, follow steps 9-10 2Insert the rope through the hole in the reel and tie
knot in the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the