2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 200Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 200

Servicing Center Crankcase Components NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
the crankcase3Mount the dial indicator so the tip is contacting tooth on the secondary driven bevel gearCD052A 9Continue
compressing the spring while guiding the spring holder onto the hubWhen slight resistance is felt, stop turning the wing
nut10Install the nut (threads coated with red Loctite #271); then tighten the nut to specification using the spanner and
torque wrench 4While rocking the driven bevel gear back and forth, note the maximum backlash reading on the gauge5Acceptable
backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting Backlash NOTE: If backlash measurement is within the acceptable
range, no correction is necessary 1If backlash measurement is less than specified, remove an existing shim, measure it, and
install new thinner shim2If backlash measurement is more than specified, remove an existing shim, measure it, and install