2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 205Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 205

11Install the front and rear secondary driven shaft assemblies into the left side of the crankcase making sure the bearing
oil strainer into position; then secure with the two screws 13Place the oil strainer cap into position making sure the O-ring
is in position; then secure the cap with cap screwsTighten securely Joining Crankcase Halves 1Apply High-Temp Sealant to
the left-side mating surface2Lightly oil all bearings and grease all shafts in the right-side crankcaseCC669 10Install the
reverse idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft 3Using propane torch, heat
the right-side crankshaft bearing until the oil begins to smoke; then join the two crankcase halves CC695 CC668 4Using plastic