2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 212Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 212

14Install the crossover tube on the water pump and cylinder head making sure the O-ring is properly positioned15Install the
Top-Side Components APiston BCylinder KEY 12345678 Cylinder Stud Bolt Nut Cylinder Gasket Pin Water Hose Union Cap Screw
O-Ring 0732-301 11Tighten the cap screws (from step 9) to specifications12Place the speed sensor housing and gasket into
position and secure with the two cap screwsTighten securely NOTE: If the piston rings were removed, install them in this
sequence AInstall ring expander (4) in the bottom groove of the piston; then install the thin oil rings (3) over the expander
making sure the expander ends do not overlapStagger the end gaps of the upper and lower thin oil rings according to the illustration