2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 218Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 218

EWhile holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valvetappet
the following procedureNOTE: Use Valve Clearance 0444-078) for this procedureAdjuster (pn Installing EngineTransmission NOTE:
Arctic Cat recommends that new gaskets and O-rings be installed whenever servicing the ATV ATurn the engine over until the
piston reaches top dead center on the compression strokeBPlace the valve adjuster onto the jam nut securing the tappet adjuster
screw; then rotate the valve adjuster dial clockwise until the end is seated in the tappet adjuster screwCWhile holding the
valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate the tappet adjuster screw
clockwise until friction is feltDAlign the valve adjuster handle with one of the marks on the valve adjuster dial 1From the
left side, place the enginetransmission into the frame; then slide the engine rearward as far as possible2Slightly raise