2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 243Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 243

12To remove the output shaft and gear, remove the nut, slide the gear off the shaft (account for shim or shims), and drive
Starter 3-214 Measuring Shift Fork (Thickness) 3-217 Measuring Shift Fork Groove (Width) 3-218 Measuring Shift Fork To Groove
(Side Clearance)3-218 Servicing Right-Side Components 3-218 Primary Clutch Assembly3-218 Inspecting Oil Pump3-221 Servicing
Center Crankcase Components 3-221 Secondary Gears3-221 Crankshaft Assembly 3-222 Driveshaft3-224 Countershaft 3-230 NOTE:
If the valve cover cannot be trued, the cylinder head assembly must be replaced 1Wash the valve cover in parts-cleaning solvent2Place
the valve cover on the Surface Plate (pn 0644-016) covered with #400 grit wet-or-dry sandpaperUsing light pressure, move
the valve cover in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted
by bright metallic finishCorrect any high spots before assembly by continuing to move the valve cover in figure eight motion