2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 249Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 249

CleaningInspecting Cylinder 1Wash the cylinder in parts-cleaning solvent2Inspect the cylinder for pitting, scoring, scuffing,
clean cylinder after honing using soap and hot waterDry with compressed air; then immediately apply oil to the cylinder boreIf
the bore is severely damaged or gouged, replace the cylinder ! CAUTION Water or parts-cleaning solvent must be used in conjunction
with the wet-or-dry sandpaper or damage to the sealing surface may result Inspecting Cam Chain Guide 1Inspect cam chain guide
for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning Cylinder 4If any measurement exceeds
specifications, replace the cylinderMeasuring Camshaft Runout NOTE: If the camshaft is out of tolerance, it must be replaced
1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations from top to bottom
and again from top to bottom at 90 from the first measurements for total of six measurementsThe trueness (out-of-roundness)