2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 253Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 253

AssemblingInstalling 1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting
Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 2Insert the rope through the
hole in the reel and tie knot in the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm
(20 in of rope free of the reel3Apply low-temperature grease to the spring and hub4Thread the end of the rope through the
guide hole of the case; then thread the rope through the handle and secure it with double knotInstall the protective cover
into the handle5Align the inner hook of the spiral spring with the notch in the reel 1Clean all components2Inspect the springs
and ratchet for wear or damage3Inspect the reel and case for cracks or damage4Inspect the shaft for wear, cracks, or damage5Inspect
the rope for breaks or fraying6Inspect the spiral spring for cracks, crystallization, or abnormal bends7Inspect the handle