2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 273Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 273

2Place the strainer cap into position on the strainer making sure new O-ring is properly installed and secure with the cap
the oil pump into position in the crankcase and secure with the three Phillips-head screws coated with blue Loctite #243Tighten
to specifications ! CAUTION After completing center crankcase components, proceed to Installing Right-Side Components, to
Installing Left-Side Components, and to In- stalling Top-Side Components Installing Right-Side Components AOil StrainerOil
Pump BGear Shift Shaft 4Place the pin and washer into position on the oil pump shaft, install the oil pump driven gear, and
secure with the circlip 1Place the oil strainer into position beneath the crankcase and tighten securely with the Phillips-head