2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 275Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 275

12Using the Clutch Sleeve Hub Holder (pn 0444-007), install the nut and washerTighten to specifications CC079D 10Install
on their respective shafts making sure the sleeve is properly positioned in the primary assembly 14Install the clutch shoe
and washer; then secure with the starter clutch shoe nut (left-hand threads)Tighten to specifications; then using center
punch, stake the nut15Install the release roller assembly making sure the four springs are in position; then using crisscross
pattern, tighten the four cap screws securelyNOTE: Tighten the four roller assembly cap screws in crisscross pattern making
sure there is no clearance between the clutch plates when secured NOTE: Note the alignment mark scribed on the primary driven