2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 280Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 280

15Insert the pin into the starter gear assembly boss in the crankcase; then install starter idler gear #1 19Install the
Housing EHiLow Shifter Assembly FRecoil Starter NOTE: Steps 1-19 in the preceding sub-section must precede this procedure
20Place the gasket and left-side cover into position on the crankcaseNOTE: It may be necessary to push or pull the splined
HiLow range shift shaft to establish covercrankcase mating 18Place the rotorflywheel into position on the crankshaft; then
install the nut on the crankshaft and tighten until the rotorflywheel is properly seatedTighten to specifications 21Install