2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 281Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 281

22Place the starter cup into position on the crankshaft making sure new, lubricated O-ring is inside the cupTighten the
assembly part way onto the shaftNOTE: Position the shift lever part way onto the splines and verify the subtransmission is
in hi rangeIf not, shift into hi range 24Place the shift stop housing assembly into position beneath the shift shaft housing
making sure the spring and stopper are correctly positionedTighten to specificationsCC045D 27Pull up on the hilow shift T-handle
and guide the T-handle stop pin into the hi range lever stop plate slot; then slide the shift lever assembly the rest of