2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 288Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 288

FWhile holding the adjuster dial at the proper clearance setting, tighten the jam nut securely with the valve adjuster handle31Place
Cat recommends that new gaskets and O-rings be installed whenever servicing the ATV 1From the left side, place the enginetransmission
into the frame; then move it rearward as far as possible2Raise the rear of the engine enough to engage the front driveshaft
into the splines of the front drive output yoke; then slide the engine forward as far as possibleCC528D CWhile holding the
valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate the tappet adjuster screw
clockwise until friction is feltDAlign the valve adjuster handle with one of the marks on the valve adjuster dialEWhile holding
the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valvetappet clearance
is attainedCD818 NOTE: Rotating the valve adjuster dial counterclockwise will open the valvetappet clearance by 0.05 mm (0.002