2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 316Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 316

3Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
cylinder and pistonMeasuring Camshaft Runout NOTE: If the camshaft is out of tolerance, it must be replaced Inspecting Cam
Chain Guide 1Place the camshaft on set of blocks; then position the dial indicator contact point against the shaft and zero
the indicator 1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning
Cylinder 1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations from
top to bottom and again from top to bottom at 90 from the first measurements for total of six measurementsThe trueness (out-of-roundness)