2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 322Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 322

2If the housing is damaged in any way, the housing must be replacedINSPECTING PRIMARY ONE-WAY DRIVE 3Install the pilot bushing
alignment marks on the fixed face spring holder and both pulley faces 1Secure Driven Pulley Compressor (pn 0444-121) in suitable
holding fixture such as bench vise; then remove the wing nut, holding handle, flat washer, and pilot bushing leaving the
large spacer on the compressor tool base 5Place the holding handle on the spring holder fitting the two dowel pins into the
spring holder face; then install flat washer and the wing nutTurn the wing nut down until resistance is feltCD047 NOTE: Do