2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 326Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 326

Servicing Center Crankcase Components NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
in both directions6Examine the tooth contact pattern in the dye and compare the pattern to the illustrations Checking Backlash
NOTE: The rear shaft and bevel gear must be removed for this procedureAlso, always start with the original shims on the rear
shaft 1Place the left-side crankcase cover onto the left-side crankcase half to prevent runout of the secondary transmission
output shaft2Install the secondary driven output shaft assembly onto the crankcase3Mount the dial indicator so the tip is
contacting tooth on the secondary driven bevel gear4While rocking the driven bevel gear back and forth, note the maximum
backlash reading on the gauge5Acceptable backlash range is 0.03-0.15 mm (0.001-0.006 inCorrecting Backlash NOTE: If backlash
measurement is within the acceptable range, no correction is necessary 1If backlash measurement is less than specified, remove