2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 327Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 327

ATV-0104 Correcting Tooth Contact NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction
deflection must not exceed specificationsMeasuring Connecting Rod (Big End Side-to-Side) NOTE: To correct tooth contact,
steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim Correction" chart must be
consulted ! CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue the
correcting backlashcorrecting tooth contact procedures until they are both within tolerance values 1Push the lower end of
the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting rod and
crankshaft journal CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper