2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 328Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 328

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable
Disassembling 3Zero the indicator and rotate the crankshaft slowly ! CAUTION Care should be taken to support the connecting
rod when rotating the crankshaft 1Remove the thrust washer (1); then remove the low driven gear (2) and the bushing (3) noting
the orientation of the oil hole 4Maximum runout must not exceed specificationsNOTE: Proceed to check runout on the other
end of the crankshaft by positioning the indicator contact at point and following steps 2-4 Measuring Crankshaft (Web-to-Web)
1Using calipers, measure the distance from the outside edge of one web to the outside edge of the other web 2Remove the lowreverse