2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 331Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 331

2Apply red Loctite #271 to the threads of the output shaft; then secure with the nutTighten nut to specifications; then using
each end of the shaftFI409 Assembling Crankcase Half 1Install the output shaft assembly into the crankcase making sure the
driven bevel gear, shim, washer, and nut are properly sequenced NOTE: If heating the bearing is not possible, the crankshaft
can be installed using crankshaft installing tool 4Install the drive pin (4) in the crankshaft; then apply red Loctite #271
to the threads of the crankshaft and install the crankshaft balancer drive gear (2), washer (3), and nut (1)Tighten to specifications;