2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 333Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 333

10Install the reverse idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft Joining Crankcase
and forth to ensure no binding or sticking occurs 6From the right side, install the mm cap screws (two inside the case);
then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking occursFI288A 12Place
the oil strainer into position in the left crankcase half 7In crisscross pattern, tighten the mm cap screws (from step 5)
until the halves are correctly joined; then tighten to specificationsNOTE: Rotate the shafts back and forth to ensure no
binding or sticking occurs 8In crisscross pattern, tighten the mm cap screws (from step 6) to specificationsNOTE: Rotate
the shafts back and forth to ensure no binding or sticking occurs AT THIS POINT 13Install the two alignment pins in the left
crankcase half After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side