2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 341Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 341

3Lubricate the inside wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder
coolant hose onto the crankcase union and tighten the clampCCylinder Head NOTE: Steps 1-5 in the preceding sub-section must
precede this procedure 8Install the five 10 mm cylinder head cap screws and tighten in the sequence shown to an initial torque
of 2.5 kg-m (18 ft-lb); then using the same sequence, tighten to final torque of 3.7 kg-m (27 ft-lb)NOTE: Apply engine oil
to the threads and both sides of the washers before installing the cylinder head cap screws 6Place the chain guide into the
cylinder ! CAUTION Care should be taken that the bottom of the chain guide is secured in the crankcase boss 9Install the