2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 344Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 344

23Place new O-ring on the drive end of the starter; then place light coat of grease on the O-ring and install the starterSecure
the mounting brackets 6Making sure the thermostat bleed valve is correctly oriented, install the thermostat housing and engine
damper mount; then secure with the two cap screws and tighten to specificationsTighten the engine damper stopper cap screws
(from step 5) to specifications 3Install the front through-bolt; then install the rear through-boltSecure with new self-locking
nuts and tighten to specifications 4Align the rear drive flanges and secure with four cap screwsTighten to specificationsNOTE:
It is advisable to apply the brake lever lock when tightening the cap screws securing the rear driveshaft 7Using new O-ring,