2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 352Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 352

NOTE: Check float arm height by placing the carburetor on its side wfloat contacting the needle; then measure with caliper
initial settingNOTE: Note the locations of the jets and holder during assembling proceduresCC750 3Install the slow jetTighten
securely4Install the main jet into the needle jet holder and tighten securely; then install the needle jet and needle jet
holder assembly into the carburetor and tighten securely5Place the float assembly (with float valve) into position and secure
to the carburetor with the float pin 7Place the U-ring into the pump housingPosition the spring and diaphragm assembly (lip