2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 355Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 355

8Loosen the outer jam nut securing the throttle cable to the throttle body; then route the cable out of the way9Remove the
will result 1Place all metallic components in wire basket and submerge in carburetor cleaner2Soak for 30 minutes; then rinse
with fresh parts-cleaning solventFI104A 11Use tape to cover and seal the intake opening 3Wash all non-metallic components
with soap and waterRinse thoroughly4Dry all components with compressed air only making sure all holes, orifices, and channels
are unobstructed5Inspect the carburetor body for cracks, nicks, stripped threads, and any other imperfections in the casting6Inspect
the vacuum pistondiaphragm for cracks, imperfections in the casting, or cracks and tears in the rubber7Inspect float for
damage8Inspect gasket and O-rings for distortion, tears, or noticeable damage9Inspect tips of the jet needle, pilot screw,
and the needle jet for wear, damage, or distortion ! CAUTION Any objects or liquid entering the intake opening will fall