2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 364Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 364

ASSEMBLING 1Place the new oil seal into the bearing housing; then using seal driver, gently tap the seal down until it is
will be flush with the engine when the two shafts are properly engaged ! CAUTION Failure to properly engage the two shafts
could cause serious engine damage 5With the bearing housing assembly in position on the engine, place the cover (with O-ring
installed) into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING 1Secure the
water pump to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws securely
4Place the footrest into position on the frame and loosely secure with four cap screws; then secure the front and rear fenders
to the footrest with the four torx-head cap screwsTighten the four torx-head cap screws securely; then tighten the remaining