2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 366Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 366

INSPECTING AT THIS POINT If the pump has failed earlier test and must be replaced, proceed to INSTALLING BEngage the tabs
3Rotate the fuel pump until the match marks align; then install the mounting screws and tighten securely using crisscross
patternATV2116 NOTE: If readings are erratic, clean the resistor wiper and resistor with clean alcohol and retestIf still
not correct, replace the fuel gauge tank sensor NOTE: It is important to install the fuel pump with the correct orientation
to ensure adequate float lever clearance 4To replace the fuel gauge tank sensor, use the following procedureADisconnect the
two-wire connector (A); then press the fuel gauge tank sensor toward the top of the fuel pump to release it from the mounting
slot (B) 4Connect the wires, fuel hose, and spring clamp; then turn the ignition switch to the ON positionNote that the fuel
pump runs momentarily and the fuel gauge indicates the proper fuel level5With the transmission in neutral and brake lever
lock engaged, start the engine and check for normal operationCheck for any fuel leaks6Install any wire ties that were removed;