2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 370Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 370

Accessory ReceptacleConnector NOTE: This test procedure is for either the receptacle or the connector NOTE: If the meter
tests to avoid damaging the multimeter 1Set the meter selector to the OHMS position2Connect the red tester lead to one black
wire; then connect the black tester lead to the other black wire Brakelight Switch (Auxiliary) The switch connector is the
two-prong connector on the brake switch lead above the transmissionNOTE: The ignition switch must be in the ON position VOLTAGE
(Wiring Harness Side) 3When the brake pedal is depressed, the meter must show less than ohmNOTE: If the meter shows more
than ohm of resistance, replace the switch 1Set the meter selector to the DC Voltage position2Connect the red tester to the
orange wire; then connect the black tester lead to ground Brakelight Switch (Handlebar Control) To access the connector,
remove the access panelNOTE: The ignition switch must be in the ON position VOLTAGE (Wiring Harness Connector) 1Set the meter