2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 375Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 375

2On the 400650 H1, connect the black tester lead to either primary connector; on the 500700 EFI, connect the black tester
wire; then connect the black tester lead to ground3Crank the engine over using the electric starter4The meter reading must
be within specificationAR603D 2The meter reading must be within specificationNOTE: If the meter does not read as specified,
replace the spark plug cap EFI Sensors Components PEAK VOLTAGE (400) NOTE: All of the peak voltage tests should be made using
the Fluke Model 73 Multimeter (pn 0644-191) with Peak Voltage Reading Adapter (pn 0644-307)If any other type of tester is
used, readings may vary due to internal circuitryNOTE: The battery must be at full charge for these tests CRANKSHAFT POSITION
(CKP) SENSOR To test the CKP sensor, see Stator CoilCrankshaft Position (CKP) Sensor (700 EFI) in this sectionAIR PRESSURE
SENSOR (APS) PrimaryCDI NOTE: The CDI is located beneath the seat and fender panel near the battery 1Disconnect the APS connector