2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 377Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 377

9The meter must show less than ohm Ignition Switch On the 400500, the connector is the black three-wire one beneath the steering
meter shows no battery voltage, troubleshoot the battery or the main wiring harness Handlebar Control Switches The connector
is the yellow one next to the steering postTo access the connector, the steering post cover and the right-side fender splash
shield must be removed (see Section 8)NOTE: These tests should be made on the top side of the connector RESISTANCE ! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter ! CAUTION Always disconnect
the battery when performing resistance tests to avoid damaging the multimeter NOTE: Perform this test on the upper side of
the connector RESISTANCE (HI Beam) 1Turn the ignition switch to the ON position2Set the meter selector to the OHMS position3Connect
the red tester lead to the red wire; then connect the black tester lead to the orange wire (400500) or to the redblack wire